2018 Range Rover Evoque is very difficult to program when lost all smart keys.  Here we program it in a crazy easy what via OBD only.  No EEPROM, No KVM out, no break the system.
 
Tools required:

  Yanhua tech released new module 18 for Mercedes Benz DME and ISM reflash without soldering in May 2021.
 
 

  Nissan Consult III Plus scan tool will be needed to perform the process of reflashing/reprogramming Nissan ECUs. This process works for any computer on any Nissan vehicle and is the same process if you use the factory tool (Nissan Cons...

 Some may have j2534 wrapper driver installation error when performing GM SPS programming by GM MDI/MDI2/VXDIAG VCX NANO GM.  Here is an official workaround from GM and it’s super easy.
 
 

  How-to: Programming Renault Laguna III key cards with HandsFree system using the RenOLink 1.87 interface and the Chinese replacement card.
 
 

 The last batch of CG keys was not read or written to the CGDI MB. The manufacturer CGDI MB recommends replacing the IR receiver and transmitter. There was neither time nor desire to buy it and wait. Therefore, I tried to install the IR ...

 I ordered a DOIP MB SD C4 PLUS with software xentry 2021.3 and was able to use this hard drive for 2 hours then it crashes. I was told me to change Bios to ACHI . That did nothing.
 
 

  Latest Version Of Toyota Techstream V16.00.017 tested verified working with MINI VCI J2534 cables (SV46-D1 and SV46-D). Obdii365.com provides software and driver installation tutorial here.
 
Software can be downloaded free on previo...

 Here comes the latest Version Of Toyota Techstream V16.00.020 / V16.00.017 for 1996-2022 for Toyota , Lexus and Scion including American LHD and UK RHD cars and including all CANBU / CAN BUS based.
 
 

  Hello. I am installing a Ford vcm2 and connecting it to IDS V121.01, I get this error “ Falta de concordancia entre las versiones de software VCMII IDS (Mismatch between VCMII IDS software versions)”, does anyone know how t...

  We can program key for BMW CAS4 system in 2 methods: one is to preprocess the CAS by OBD and then to program without disassembly, and the other is to disassemble the CAS and use the Xhorse VVDI Prog programmer to read the data and then...

  Question:
How do I know the Lonsdor JLR license is activated in my K518ISE machine?